Extract sections

Feel free to ask any question here
Post Reply
krd
Posts: 1
Joined: Sun Oct 29, 2017 10:55 am

Extract sections

Post by krd »

Hello!

I had been trying the extract sections tool to bring the profile of the point cloud along a polyline as shown in the figure. However, the next time i tried the tool, it was giving the following profile. Previously it was a nice representation of the point cloud. Is there something that I am doing wrong. I believe I have followed the same steps. I need to extract the profile in order to measure the distance between the peaks of the cloud.
Attachments
CC.png
CC.png (85.13 KiB) Viewed 922 times
daniel
Site Admin
Posts: 7332
Joined: Wed Oct 13, 2010 7:34 am
Location: Grenoble, France
Contact:

Re: Extract sections

Post by daniel »

Hum,

Not something I'm aware of. Have you tried with the latest 2.9 version?

And what about the 'min edge length' parameter, is it too small enough?

Otherwise don't hesitate to send me your data so that I can test on my side.
Daniel, CloudCompare admin
Post Reply